VEGA has been developing sensors for radar level measurement at its factory in Schiltach for 30 years. A new era began a few years ago with the introduction of
VEGAPULS sensors with 80-GHz operating frequency. By focusing the emitted signal more precisely, the received measurement and interference signals can be separated more easily – making the measuring process much more reliable and simple. Many measuring tasks that had once been considered impossible became commonplace thanks to this technology. Radar sensors from VEGA are now in use in more than 750,000 applications worldwide. The cost of radar sensors has fallen dramatically over the years and standard versions, now the same price as ultrasonic sensors, have become very affordable.
And the 80-GHz radar series even offers a number of additional advantages over ultrasonic sensors. One of the most important is undoubtedly its independence from external conditions – the radar sensor is just as unaffected by temperature fluctuations, vacuum or high pressures as it is by dirt and pollution. As a result, the level sensors are virtually wear and maintenance free and remain in service for many years. The beating heart of these new sensors is a radar microchip newly developed by VEGA and specially optimised for the requirements of level measurement. Thanks to the small design, the sensors are not only very compact, they are also so inexpensive that they can replace the previous ultrasonic sensors in almost all applications.
It was precisely these features that predestined them for use in the wastewater treatment plant of the Al Rawabi Dairy. There, the previously used level measuring equipment, which was used as overfill protection, quickly reached its limits. Above all, it was the foam that caused difficulties for the measuring instruments, but the heat from the sun (after all, the plant is located in the middle of the desert), condensate and turbulence from the huge agitators on the tank floor also played a role. Not only did the ultrasonic measurement deliver unreliable values, but the hydrostatic sensors that were subsequently used had to be cleaned again and again because of the heavy sludge on the floor.